thanks bravootome

Hello
I have made a fridge compressor so now i am going to get a higher pressure than i got with my tire compressor. I am wondering if anyone knows the pressure rating on pvc and whether the pvc fittings with burst or break before the tube does?
Please relpy

thanks bravootome for replying
is the termic resistance the coil on the motor.

I have managed to make an air compressor out of an old freezer. In pumps air fine but sometimes it stops and then starts up a few minutes later. Does anyone know the problem or know how to prevent it.
Please reply
Thanks

but bbs dont need as much volume?

*pengun not penguin

I only have a compressor that goes to 100psi, so what is a fridge compressor? I have always wondered. I want to put a regulator on so i can adjust the pressure in the firing tank to a lower pressure than in the main tank. I only want to shoot bbs in this multi-shot so i don't need as much pressure a...

Hey, I am only new to air cannons. I have made a very simple single shot air cannon and wondering if anyone had a design for a multi-shot air cannon using a slide valve and a quick exhaust valve. Also my air compressor only goes to 100 psi so is it worth getting a pressure regulator. If I get a regu...

Hey
very nice penguin, awesome
how is it triggered?

My compressor can only pump to 100 psi max, but ive hear little about shock pumps and what pressure can they go to? What the difference between a shock and bicycle pump?
Please answer if can
Thanks Andrew_J

To cammyd would this be the kind of set up?

Hi, My last air cannon was a quit simple single shot air cannon made out of no time but i now want to make a multi shot ball bearing rifle. I want to use a regulator to be efficient of my air and I was wondering if anyone could draw a basic diagram of one. Also would a 1/4'' quick exhaust valve be t...

Thanks,
How much pressure should I have for ball bearing to get good power with a medium size air tank

The blow gun wouldnt let the air through as fast as a qev or solonoid valve so you would want the projectile to be a tight fit and the valve to be as big as you can
Andrew_J

Hey people,
I was wandering if anyone could reply some sujjestions about this design.
And would it work well with about 5mm balll bearings.

Please comment I haven't made many air guns and would like information
Thanks