Page 1 of 1
Request for Milled QEV
Posted: Sat Jul 12, 2014 8:00 am
by farmerboy32
Hello, i would like to request to any one that has the tools and the spare time a QEV. I would like for it to be able to take up 300# and for it to as asmall as possible. The largest dimensions i would want are 1/2" in width 3-4" in height and 4-5" in length. The ports need to be standard 1/2" threading. Thanks for reading!
Re: Request for Milled QEV
Posted: Sat Jul 12, 2014 1:26 pm
by fenrir
By the way, you should have posted this in the official machinist thread. You can buy a qev on ebay that exceeds your requirements, and it's cheap.
Re: Request for Milled QEV
Posted: Sat Jul 12, 2014 4:01 pm
by jrrdw
fenrir wrote:By the way, you should have posted this in the official machinist thread. You can buy a qev on ebay that exceeds your requirements, and it's cheap.
Yup. :bigsmurf:
Re: Request for Milled QEV
Posted: Tue Jul 15, 2014 7:42 pm
by farmerboy32
Ohh, my bad. Thanks though. Question, is there any key things i should search for in particular?
Re: Request for Milled QEV
Posted: Wed Jul 16, 2014 3:58 pm
by jrrdw
Port size.....