Hi
I just bought some new parts to upgrade my spud gun recently, but I'm not so sure whether this 3" endcap is safe or not. I thought it looked a little different from the other end-caps I had, but wasn't sure whether it was like that because it was bigger.
On the edge it says SCH40 PVC-1 IPS [NSF-PW] 3 DURA USA
but I don't see any pressure ratings.
I've also took a picture, sorry about the crap quality (cell phone pic). Anything look obviously wrong?
Thanks in advance!
Is this fitting pressure rated?
-
Yonderknight
- Private 2
- Posts: 32
- Joined: Thu Aug 17, 2006 7:16 pm
- Attachments
-
- 04-27-07_1739.jpg (19.34 KiB) Viewed 1381 times
Well it says nsf-pw so I think its pressure rated, but I don't know what pressure its rated to.
I wonder how much deeper the ocean would be without sponges.
Right now I'm having amnesia and deja vu at the same time. I think I've forgotten this before.
Add me on msn!!! insomniac-55@hotmail.com
Right now I'm having amnesia and deja vu at the same time. I think I've forgotten this before.
Add me on msn!!! insomniac-55@hotmail.com
-
Yonderknight
- Private 2
- Posts: 32
- Joined: Thu Aug 17, 2006 7:16 pm
Hrm okay, as long as it's not the "other kind' of pipe that isn't rated. I'm not going to be pushing the pressure too high.
Thanks =).
Thanks =).
-
Specialist
- Specialist 3
- Posts: 375
- Joined: Sun Mar 18, 2007 4:22 pm
- Location: Illinios
- Contact:
i think i have an end cap similiar to it and i think its only rated to 23 psi or somewhere around there. i could be wrong though.
-
Specialist
- Specialist 3
- Posts: 375
- Joined: Sun Mar 18, 2007 4:22 pm
- Location: Illinios
- Contact:
oh sorry then. i have an end cap that i use for combustions thats only rated to like 30 or something. sorry again.