pneumatic skewer sniper rifle bolt action

[rhys_pesantsrevolt]

having trouble with how to shoot skewers from the pneumatic i will put a diagram of the sniper up in under 7 hours

[Saboo]

try and make the skewer a perfect fit to the barrel by perhaps increasing the width with rubber fittings or duct tape

[rhys_pesantsrevolt]

i may have sone 2mm pipe of not how else so it can fit in a mag

[Saboo]

Why does the mag. have anything to do with this. Once you have your gun made, you can build the clip to suitr the gun, not the gun to suit the clip

[homedepotpro]

you will have to use extreme pressures to get good performance. lets say the barrel is 1/16'' and your operating at 100psi you will have .39 pounds of pressure acting on the project tile. may i suggest a sabot.

[rhys_pesantsrevolt]

ok ive decided to change it from a skewer gun which will be too hard to a 5mm bb rifle what vlve should i use i was thinking of using a solenoid

[NoXi]

use punctuation. I can barely understand what your trying to say.

[f.c]

just make a cloud if you're gonna make a bb gun for you're first time.

[Redcoat]

Nah Rhys, It would be fine to make it skewer. I'll draw up a diagram for you.

[rhys_pesantsrevolt]

use punctuation. I can barely understand what your trying to say.

this is what i was saying i have decided to change it from a skewer gun to a ball bearing gun.
what valve should i use i am thinking of using a solenoid valve
well thats what i was thinking but because i cant just go to the good old corner shop and by 10000 bbs i need single shot i only have 15 bbs at the moment and i dont want to waste them
so i have designed a gun that uses a spring mag wiht 5 bbs in it and it will be designed to go single shot.
also what do you people think of making a grenade cup that shoots 10mm round by 3 inches long from the end of this rifle as soon as i get my scaner working i will post the diagrams
Henry give me the drawing this monday if you can sorry i couldnt come 2day

[Redcoat]

also what do you people think of making a grenade cup that shoots 10mm round by 3 inches long from the end of this rifle

You stole my idea.

[Mitchza89]

What sort of power are you looking to get with a BB? Because I'm making a single shot BB gun and plan to get over 1000fps.

[Redcoat]

If you were going to make ab gun and plan to get that high and do excessive damage your best bet would be making a piston valve other than that Rhys,
You should just make a cloud or shoot batteries and potato slugs and marbles from your gun.

[rhys_pesantsrevolt]

henry i ame using sparkler dust / my secret substance to make short ranged flash bangs
and i have no idea about the fps i think 500 would be ok i guess

[rhys_pesantsrevolt]

does anyone know how to rifle th barrel im thinking of having a small attachment on the end that is rifled will this work