SpudFiles

i am currently making a pneumatic cannon with a sprinkler valve. When i tested the valve after modding it with half inch ball valve, air simply just leaks out the Pilot. I have searched the fourms and one said that the equalization hole may be too big. my question is what is the equilation hole?

http://www.orbitonline.com/products/Val ... 16/01/218/

this is the valve i have and in the center of the diaphram is an Aluminum rod that slips through a plasitc disk in the diaphram. Is this the hole? Any and all help will be welcome

i can tell you now the metal ride is most likely the guide rod im not too sure on the rest im sorry

yea thats what i think now but i am not too sure

thanks

ahh yeah buddy I was the same as you, i tried to mod mine aswell but then a mate of mine told me that i was using the wrong sprinkler valve. but you know i could be really wrong lol... try these if you want to:

http://www.orbitonline.com/products/Val ... 16/04/643/
http://www.orbitonline.com/products/Val ... 16/04/644/

i think that is what i am going to have to do just get a whole new valve

No you dont need to buy an entire new valve. Another guy just a few days ago had the same problem. He had screwed in the nipple for the ball valve too far and the diphragm inside would not actuate. Just make suure the nipple going to the valve isnt in below the plastic

but my valve isn't, there is a plastic peice that is in the valve that prevents me from even touching the diaphram i. i am going crazy over this stupid valve