SpudFiles

Hi everyone!
I recently found a water boiler pressure safety valve and I was wondering what I could do with it. It doesn't seem like I could do much so I'm open to any ideas. I've been thinking about making a better hammer valve using the body of thing.[/img]http://c.shld.net/rpx/i/s/pi/mp2/3125/a ... eda4533edb[/img]π[/img][/youtube]

Not much, it's not even a pop-off type valve if I recall correctly. Not very useful as a hammer valve either, because it's the "wrong way round".

agree with jack its a pressure relief valve different setup from a standard air pop off valve seen those on hot water heaters and such

whawhasiscumba wrote:Hi everyone!
I recently found a water boiler pressure safety valve and I was wondering what I could do with it. It doesn't seem like I could do much so I'm open to any ideas. I've been thinking about making a better hammer valve using the body of thing.[/img]http://c.shld.net/rpx/i/s/pi/mp2/3125/a ... eda4533edb[/img]π[/img][/youtube]

You can replace it with the one in your water heater now ! Lol

Haha OK thanks everyone, I'm heading to the hardware store to make a hammer valve NOT out of this.

Thanks for the help!

-whawhasiscumba