SpudFiles

hello fellow spud gunners, my name is Cameron and i have built a basic pneumatic with a jar top valve, 3" chamber, and interchangeable 2" SCH 80 or 3" SCH 40 barrels

the above image is the origanal configuation that i used to launch super balls/apples, plenty of power for me.



what i am now trying to do is launch tee shirts/large chuck it balls(which fit perfectly in 3in sch 40 btw) and i have a few questions
1 whats the best/easiest way to attach the barrel to the chamber, i have noticed wood being used alot so i tried with my original but as you can see im no wood-smith. was thinking about an old rubber bushing i had laying around from past automotive projects with a big worm drive clamp so i can change barrels easier
2 i want to launch tee shirts so ill need to add portability. i was thinking either a 5-10 pound CO2 tank with industrial type reg or similar sized nitrogen tank and industrial reg concealed in a back pack, but am open to suggestions
im sorry for the grammar and spelling errors this may contain me no good at sentence structure
Damage videos to follow if i get some good feedback 8)

cjhart87 wrote:wood-smith

To be honest there is nothing wrong with your current setup, just trim the sides of the wood down to they are less obtrusive.

i want to launch tee shirts so ill need to add portability. i was thinking either a 5-10 pound CO2 tank with industrial type reg or similar sized nitrogen tank and industrial reg concealed in a back pack, but am open to suggestions

Go with nitrogen or HPA, and make sure you have a safety pop-off valve to make sure you cannot accidentally over-pressurize.

Thanks Jack, now I need to find someone with wood working tools and a trip to the welding supply store
[youtube][/youtube]
heres a crappy video of it firing apples this fall

Interesting little *cough* at the end there - did you press the blowgun valve and release, then press it again?

I'm busy building a similar setup. What sort of range are you getting with the 2" barrel?