SpudFiles

so i will make a help topic you get on hear ask me a qustion and i will try to help you the best i can

You can help ease my boredom by posting a sketch of your latest hybrid design.

Or a picture/drawing of your pneumatic whose chamber exhibits no pressure loss from each shot.

okay i do not know how to insert images and i have chrombook but is there a way i can skecth on the platform though

i can not show you the design but i can tell you how to put it together and give you instructions whould that be okay with you

which should i start with advanced pnumatic or advanced hybrid i will start with my advanced multi gas system hybrid

so first of all i take 3 tanks 1 oxy tank 1 propane tank and 1 bead seater i put pipe on front of the bead seater i then put propane and oxy tanks weld them 2 the pipe the must ables to be reafeled and drill hole in pipe the pipe must be steel and have thread at the end of it then a second valve and then a niple then but a female unions and weld pipe to the front of the female union and put zippo lighter at the front then load the union with the projectile fire it out with the zippo at the front once it exits the barrel the gases combust and through the patato out very fast i no it was over 2000 fps
all parts mustt be mettal too

metal sorry about spelling

as for the pnumatic spudgun i will tell you that in sections

section 1 modifing pcp air rifle tank for pnumatic spudgun valve first step change front valve to be a one way valve then drill hole at the back of the tank and weld a one way on the other side and drill hole in the tank were the one way valve is

section 2 how to get the firing pin system work conect tee to section 1 put a hex bold in one section and a long screw facing up to next the other tee back of that tee a psi guage and front of that having a one way valve that faces torwads a buterflly valve that has a pin welded to it with a spring next to the way that opens it that way if you push down you can get semi auto then put a 5 in long screw in between that and a one way valve the put a nother tee facing down wards for the magazine as for the magazine use screw with cap and spring to force ammo up with a ball valve in front of the mag and nipple
to connect them than put a 25 in long screw and one way valve facing away of that and a tee in between those to and a nother one way valve facing backwards this way the air gets stuck then put a nother 1 way valve facing downward and put a air hose adapter on it then connect that to the air canister

is there anything elese that you whould like to ask me

what are some of your guys favorite guns

quinn whitsitt wrote: ↑

Mon Feb 19, 2024 8:58 am

okay i do not know how to insert images and i have chrombook but is there a way i can skecth on the platform though

1. Go to this website: https://mspaint.humanhead.com
2. Draw your design
3. Click the save button, which will save your drawing to your chromebook as an image file ("myfirstspudgundrawing.png")
4. Re-visit spudfiles.com, go to this post, and click the image button on the "post a reply" draft writing box, it looks like a square with a mountain and a sun in the top left
5. Once you've clicked that button in step 4, select the file, "myfirstspudgundrawing.png", or whatever you chose to save it as - and proceed to upload it
6. Voila! you now have created a spudgun drawing and uploaded it here!

i tried that it did not work it said site is not secure but is there anything i can do to help