SpudFiles

Heres some damage pics to 2 sweet tins, the quite thick ones, it went through 4 layers of it in one shot and then left a huge dent in the ground.

The ammo was the ball shown in the pic, about 75g of steel that fit almost perfect into 28mm pipe, I put some duct tape on it though so it wouldnt fall out the barrel when aiming down.








And the dent left in the ground.

That's pretty crazy, through four at once. What PSI were you shooting at?

116psi because thats all my compressor goes up to.

Thats nuts mate! well done!! do you think if you had a better compresser would you be able to go higher?

Bubba

Yer, the valve is rated to 145psi but someone has took one to 240psi so I could take it to that and it would be insane lol

This is the gun i shot it with by the way.
Its the top one not the pistol.

That S#@T be crazy mate! good looking gun!! Hope you get the exrta psi to ramp it up! u'd be able to go through car doors soon!!

Bubba

that is insain, nice gun to, you should get like 10 of them and i bet it would still go through all of them

Fill it up with the compressor then top it off with a hand pump. 20psi or so is a big difference

Nice pistol BTW, I like the fill tube.

that's crazy

ever tried shooting out a bunch of small ball bearings like a shotgun?

All I have to say is you have good taste in Candies and Weapons.Bravo!