i wont be able to shoot fast, right now im getting the H/o2 mic directly from electrolysis.
new spudgunner
im trying to keep as low as possible, and i just found an weldeing kit
i wont be able to shoot fast, right now im getting the H/o2 mic directly from electrolysis.
i wont be able to shoot fast, right now im getting the H/o2 mic directly from electrolysis.
keep what as low as possible? cost? be safe and pay a little more money for alot more reassurance, i would much rather pay an extra ten bucks than have something blow up in my face
i never said it couldn'tEddbot, I'm pretty sure a soda can can't handle 250 PSI.
low cost as possiable, i think ile go with an entirerly new combustion chamber, possiblly all metal, most of it being copper.
-
TurboSuper
- Corporal 5
- Posts: 986
- Joined: Thu Jun 16, 2005 1:44 pm
- Been thanked: 1 time
Sounds like an oxymoron to merp181 wrote:low cost as possiable, i think ile go with an entirerly new combustion chamber, possiblly all metal, most of it being copper.
"If at first you dont succeed, then skydiving is not for you" - Darwin Awards
Copper isn't that expensive. Brass or titanium would be much worse.
As for using a copper combustion chamber, it sounds like a fine idea. Steel would be cheaper and last longer, and is just as strong (or moreso) than the equivalent in copper. And you don't weld copper, you solder it, or use compression/flared fittings. Either that, or you could use Just For Copper adhesive, which is relatively strong (rated for 500 psi), and possibly quicker than soldering (with no tools required).
As for using a copper combustion chamber, it sounds like a fine idea. Steel would be cheaper and last longer, and is just as strong (or moreso) than the equivalent in copper. And you don't weld copper, you solder it, or use compression/flared fittings. Either that, or you could use Just For Copper adhesive, which is relatively strong (rated for 500 psi), and possibly quicker than soldering (with no tools required).
Spudfiles' resident expert on all things that sail through the air at improbable speeds, trailing an incandescent wake of ionized air, dissociated polymers and metal oxides.
yep, i just gotta ask my home deopt if they will cut the tubes to specified lengths, i have no metal shop or anything.
for a BBQ lighter, what is a good length for the spark, right now im thinking of medium, to get a bright blue spark
for a BBQ lighter, what is a good length for the spark, right now im thinking of medium, to get a bright blue spark
If you don't even have a hacksaw, then I strongly suggest that you get one. They are cheap, widely available, and absolutely necessary if you are working with metal tubing.yep, i just gotta ask my home deopt if they will cut the tubes to specified lengths, i have no metal shop or anything.
Spudfiles' resident expert on all things that sail through the air at improbable speeds, trailing an incandescent wake of ionized air, dissociated polymers and metal oxides.
i have a hack saw, but i might as well have them cut in 30 sec then me cutting . they usually cut other stuff for free
. they usually cut other stuff for free