Ok I was planning on filling the cap with epoxy or using a threaded plug, also I'll use the single layer then slide a piece of 4 inch pipe over it and epoxy it in place, this isn't needed but if some how it does fail I should provide a small degree of protection, and will
make it look cleaner,one goal with this is to make it look as much like a spray and pray as possible.
A Few Advanced Combustion Questions
-
clemsonguy1125
- Sergeant 5
- Posts: 1485
- Joined: Tue Jul 21, 2009 4:00 pm
- Location: East Coast
That is all.