Page 1 of 1
How Do You Calculate PSI In Propane
Posted: Sun Feb 14, 2010 8:30 am
by Woody
I'm looking to get a 4% propane mix in the chamber (which I heard was best, correct me if I am wrong). I'm guessing its some calculation using volume of the fuel metering chamber and the combustion chamber, but I wasn't able to find anything anywhere so I'm asking you. Also, say I had a small setup and the required fuel psi would force the hose off the barb or something. In that case how would i split the propane up into 2 doses. If anyone could help it would be greatly appreciated.
Posted: Sun Feb 14, 2010 8:48 am
by Crna Legija
you can use
this calculator to find out
Posted: Sun Feb 14, 2010 9:14 am
by spudtyrrant
-_- wrote:you can use
this calculator to find out
correction, can use
this calculator to find out
Posted: Sun Feb 14, 2010 10:35 am
by Woody
Its the same calc as -_- gave me spudtyrrant. Either way thanks
Posted: Sun Feb 14, 2010 4:53 pm
by MrCrowley
You can also calculate it yourself if you go to the Hybrid Discussion Section and click on the sticky HYBRID FUELING 101.
Posted: Sun Feb 14, 2010 5:31 pm
by spudtyrrant
Woody wrote:Its the same calc as -_- gave me spudtyrrant. Either way thanks
oh it just came up as the Burnt Latke home page on my computer