Page 1 of 1
Why does my micro just stop working?
Posted: Fri Dec 22, 2006 5:04 pm
by modernartistlathey
It works fine, then just stops, then after a while of being left, works fine again.
Some residue builds up coating the inside, if I get rid of it, will it help?
I use deodorant btw.
Cheers
Lathey
Posted: Fri Dec 22, 2006 5:16 pm
by PVC Arsenal 17
More than likely you are spraying in too much and the mixture inside is too rich to ignite. Ease off on it a bit and see what happens.
After each shot, open it up and shake it around to let some air in.
Use some acetone (nail polish remover) to get rid of the residue.
Posted: Fri Dec 22, 2006 6:53 pm
by jjjd
your probable getting to much exaust buid up in the chamber, this is why most guns have fans, just open it and wave it around
Posted: Sat Dec 30, 2006 11:34 am
by newkidspudster
it should help wipe it clean after every firing session.dont let the gunky stuff sit in there.