Page 1 of 1

help! on my spud gun

Posted: Mon Apr 09, 2007 8:02 pm
by pimp
could i do a 2 inch sch40 pvc combustion then reduce to 3/4sch 40 pvc for a barrell or 3/4 is to small? thanks in advance

Posted: Mon Apr 09, 2007 8:10 pm
by hi
thats perfectly safe and practical, i dont know why you couldnt. you would need a bushing, i doubt they make reducers that small, but i dont know.

Posted: Mon Apr 09, 2007 8:13 pm
by Specialist
if you go to your local plumbing supply store i bet you will find the fittings just bring the two pieces and ask someone to help you. :D

good luck!

Posted: Mon Apr 09, 2007 9:06 pm
by homedepotpro
the only problem with that is getting the right fuel to air mix. it's really hard in small chambers

Posted: Tue Apr 10, 2007 11:18 am
by PAspuder
Yeah I just built a new combustion gun with a smaller chamber and it is really hard to get it to ignite so I think im going to get rid of it and make one with a larger chamber.

Posted: Thu Apr 19, 2007 8:54 pm
by Bubba05
yeah getting a bigger chamber mite be the trick and you can get reduciers to go that small.

Bubba