Need some help building an airsoft vortex gun.
Iv'e decided to take a shot at building one of these. I have the air compressor, a 3-gallon air tank, air nozzle, lots of pipe and tubes, tons of stainless steel and brass, a milling machine and two metal lathes. I just need a diagram of where the hopper, nozzle, vortex block, and barrel goes to get the most fps and rps possible for an airsoft vortex gun. Thanks in advance!
use the search function. there are lots of great examples on this site.
jackssmirkingrevenge wrote:I wonder... if you put flammable vapours inside a lady... could you get her to diesel?
POLAND_SPUD wrote:Anything is possible with the proper 3-way valve.
-
jackssmirkingrevenge
- Five Star General
- Posts: 26203
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 569 times
- Been thanked: 344 times
Have a butchers at the wiki article, plenty of tips on performance optimisation and it's a good place to start.
hectmarr wrote:You have to make many weapons, because this field is long and short life
-
jackssmirkingrevenge
- Five Star General
- Posts: 26203
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 569 times
- Been thanked: 344 times
A diagram of what you mean by "vortex" and "hopper" would be most helpful 
hectmarr wrote:You have to make many weapons, because this field is long and short life
