Paintball remote line into a hammer valve
I was looking at my co2 tank remote line a few mins ago and the knob came off. As I was looking at it I got an idea of turning it into a hammer valve. It doesnt seem like it would be too difficult. Just file the threads smooth and add a spring. Might have to sleeve the shaft where the threads were so its a snug fit but still able to slide freely. Has anyone tried this?
- Attachments
-
-
jackssmirkingrevenge
- Five Star General
- Posts: 26203
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 569 times
- Been thanked: 343 times
Do you mean using the tank pin valve itself as a hammer valve?
You're not going to have a lot of flow so it would probably only be useful for small caliber applications.
You're not going to have a lot of flow so it would probably only be useful for small caliber applications.
hectmarr wrote:You have to make many weapons, because this field is long and short life