Page 1 of 1
Airsoft Flamethrower
Posted: Thu May 26, 2011 5:06 pm
by timebmb757
Just finished my first fully portable strafer, which I intend to use as an airsoft flamethrower.
Runs off regulated CO2 and uses a machined nylon vortex block.
I still have a little asthetic work to do on the backpack, but other than that, it shoots great, so Im happy.
Fully assembled (with hose) pictures soon, as well as a demo video hopefully.
Posted: Thu May 26, 2011 5:11 pm
by Lockednloaded
Looks good, but why use the pressure washer with airsoft pressures?
Whats the ID if your barrel?
Posted: Thu May 26, 2011 6:09 pm
by timebmb757
Lockednloaded wrote:Looks good, but why use the pressure washer with airsoft pressures?
Whats the ID if your barrel?
Pressure washer was for convenience mainly, seeing as it is essentially pre-molded handle that would otherwise be some hackjob that I would have had to do myself
The ID of the barrel is around 6.04 I would assume, seeing as it is a stock airsoft AEG barrel.
Posted: Thu May 26, 2011 9:17 pm
by Gaderelguitarist
You're killing me with that zip-tie, but I like it regardless.
Posted: Fri May 27, 2011 3:44 am
by Doctore
AWESOME!!!!
We want to see it in action.
Posted: Thu Feb 16, 2012 8:55 pm
by Cpt Obvious
inline vortex I take it?
and where did you get that air tank? Im looking to build something similar
and stock inner airsoft barrels are 6.08.
Posted: Sat Feb 18, 2012 2:52 pm
by Brian the brain
Looks clean!
Do you use a plunger and spring to drive the bb's towards the vortex block?
Works wonders.
That way you can fire it upside down even...