SpudFiles

Hi everybody
I saw this gun here, [/url]http://www.spudfiles.com/forums/adjusta ... 4.html[url]. and I really liked it, simple and really powerful relatively to the pressure he was using and the accuracy is very reasonable .
As I have a fridge compressor and a paintball tank with a regulator, I see no reason to not to try build one for my self. So today I use a blowgun, a o-ring detente(made from a push to connect hydraulic fitting), the air tank and I took it to make some shots. The bottle with charged to 40 bar, regulate to 150 psi. The power was great, but the accuracy and consistency are really bad . The poor accuracy was because I didn´t make a barrel for it yet, but the consistency I don´t know much any ideas?

looks good! what material did you use for the stock on your sniper rifle, AND this?

looks good! what material did you use for the stock on your sniper rifle, AND this?

Fiberglass,I think?

Wyz,any damage pics or video???

Doctore wrote:

looks good! what material did you use for the stock on your sniper rifle, AND this?

Fiberglass, I think?

Looking at it, I would say vigorous sneezing

Damages? well there was a LOT as the o-ring detente only works at 200 psi but somebody thrawed all the targets away before I took any pictures. And this thing is to dangerous for me to use my video camera.
stock made with polystyrene covered with epoxy
As the o-ring detente was too strong, I´m going to try a non air tight spring detente