Page 1 of 1
What size threading is this?
Posted: Mon Jan 16, 2012 10:48 pm
by Pneumaticology
Recently i decided it would be appropriate to get of my arse and get a job. So i did, and its pretty well paying too, so hopefully i will soon stop annoying you with my 'what is' and 'what if' posts and have some completed guns up soon
Anyway, i was wondering if anyone knows what threading the end of this adapter is, it fits into a standard paintball gun.
It looks like 1/2" NPT, and i hope it is.
Posted: Mon Jan 16, 2012 10:56 pm
by mobile chernobyl
from zdspb.com:
"ASA threads- 1/2 NPS -Female threads only. The opposing male threads are smaller to allow clearance."
the threads on the end of that 12g adapter are considered ASA threads in the paintball world...
Posted: Mon Jan 16, 2012 11:06 pm
by Gun Freak
JSR has put them directly into a 1/2" BSP ball valve, I think.
Posted: Mon Jan 16, 2012 11:07 pm
by Pneumaticology
Smaller, so they wouldnt fit into a normal 1/2" Female NPT properly?
Posted: Mon Jan 16, 2012 11:29 pm
by warhead052
Gun Freak wrote:JSR has put them directly into a 1/2" BSP ball valve, I think.
If you can, send me a link? I just thought of something, and if that works then it would be perfect.
Pneumaticology, if all else fails, get a fitting that fits it as tightly as possible, screw it in until it won't move, then fill the gaps with jb weld or equally strong adhesive.
Posted: Tue Jan 17, 2012 3:44 am
by Petitlu
this is my first PAC!
threading is the 1 / 2 BSP, here it is screwed to a plumbing fitting
