SpudFiles

Hey guys! Does this quick opening globe valve (link below) open fast enough for a pneumatic spud gun? Thanks!
http://www.mcmaster.com/#hydraulic-globe-valves/=inuerb
(scroll down a little)

no that will not work, you want this figure (F) right angle valve and or quick exhaust valve!!!

http://www.mcmaster.com/#exhaust-control-valves/=inuzch

I have to say this. Go dust collector there the best you can get for a valve thats sold

http://www.spudfiles.com/forums/viewtop ... tml#352498

links to buy one
http://www.ebay.com/itm/Goyen-Diaphragm ... t_362wt_80

offer him thirty bucks.

Ah thanks guys! I think I will get the right angle valve so that I can just buy everything from mcmaster.
newbie question time!
What do I do with the three holes (hehehe) on the mcmaster valve? There is the exhaust, the inlet, and the outlet.

doomburger wrote:Ah thanks guys! I think I will get the right angle valve so that I can just buy everything from mcmaster.
newbie question time!
What do I do with the three holes (hehehe) on the mcmaster valve? There is the exhaust, the inlet, and the outlet.

One of the side ports is the vent, you put your barrel there, one opposite it is the pilot port you need to fill valve and pilot valve there the last port witch makes the 90* is the chamber port.

I think your should read the piston valves explained visually thread.

Ah thanks, will check out the piston valves thread.