Page 1 of 1
How do u muzzle breake your barrel
Posted: Wed May 08, 2013 4:01 am
by cstru18
Hey everyone I'm was looking on how to muzzle break a 6mm barrel and I'm wondering when porting the holes do they have to be on a angle or can they be straight thanks in advanced.
Posted: Wed May 08, 2013 4:04 am
by jackssmirkingrevenge
It doesn't matter, completely useless on a small pneumatic...
Posted: Wed May 08, 2013 4:10 am
by cstru18
I wa just reading threw some forums and come across it cause I wanna improve the accuracy of my new airsoft gun I'm in the progress of building.
Posted: Wed May 08, 2013 4:40 am
by Zeus
Porting works to bleed off excess gas, for a pneumatic like yours, which has a massive excess anyway, no amount of porting will hell you just can't deliver that little gas through a QEV.
Not to mention the effect is so minimal, you won't notice until you really get into it, and this comes from an airsoft bloke.
Posted: Wed May 08, 2013 4:46 am
by cstru18
I'm just trying to find ways to increase the accuracy of my new gun btw I just got the .25g goldenball bbs 2day. Excellent service from airoz
Posted: Wed May 08, 2013 5:03 am
by Zeus
Unless you're going for a hammer valve, it honestly won't help, bar reducing velocity by a few FPS. Concentrate on a stable hopup if you're using one, I prefer R-Hops myself, but I've seen good results from an E I hop too.
Get a 6.04mm barrel, as long as you like, even drop the hopup for a thing called an LRB, which curves the barrel instead of spinning the BB, far better.
The fella who runs AirOZ is a top bloke, always ships that quickly.