SpudFiles

Ok so i tapped one of my m4 mags to have a male quick connect fitting basically sticking out the side of it so i can connect my remote with a female quick connect. However i have been trying to figure out how to do what this guy did in this video:

https://www.youtube.com/watch?v=z3f0DYB ... bjVF1IDbAw

I thought he may have bought the 20rd mag (since the top part comes right off) and somehow connected a hose to get air directly into the gun but i cannot seem to figure out a way to do it now that the mag is in front of me.

Please help if you have any ideas as he is very stingy with his info. He has a video on how to do it but it says it's "private" Also i need help with how to set up an inline regulator to somehow run between my tank w/ primary reg and my remote.

Calling him stingy wont help your cause, try asking him nicely...

"this guy" is a member of this forum and if he did not wish to share the information then I'm sure he has his reasons.

So you're the same guy on YouTube hum? I had a "how to" but I suddenly realize I haven't seen any other and quite a lot people paid me to make for them so I removed it. Nothing special I know, but it pays my parties so... If you think it's unfair, then take your own effort to figure it out
A little hint: You can do the same with drum mags, they sell well too
On the regulator, I do have a tutorial showing step by step how to obtain desired pressure, I've lowed and raised all my standard paintball regulator for custom needs.