Page 1 of 1
Fittings Help
Posted: Wed Jun 25, 2008 4:16 pm
by DrowningTrout
I know nothing about PVC Fittings...
Problem: Need to take a 2" SHC-40 PVC Pipe, and bring it down to a 1" for a sprinkler valve.
Could I use a Bushing?
Like This:
http://www.atozsupply.com/2_x_1_PVC_Bus ... 00$7B$86$B
This:
http://www.plumbingsupply.com/pvc.html#bush
Or This:
http://www.plumbersurplus.com/Prod/PVC- ... 54/Cat/754
These are all the same right?
Please tell me what to use to bring it from 2" to 1"!
Posted: Wed Jun 25, 2008 4:29 pm
by jonnyboy
You need a bushing (like you showed) with a threaded adapter to fit the sprinkler valve.
Posted: Wed Jun 25, 2008 4:35 pm
by DrowningTrout
http://www.plumbingsupply.com/pvc.html#bush
Slip Threaded Bushings - Spigot x Fips - #438
2" Spigot x 1" Fips
? That work? Link me!
Thank You for the Help!!!
Posted: Wed Jun 25, 2008 10:13 pm
by ralphd
Spigot means pipe. It will be the same size as the od of the size pipe listed.
Posted: Wed Jun 25, 2008 10:15 pm
by SEAKING9006
He doesn't need a threaded adapter if he gets a valve with solvent slots. That's what I got for my CA1.
Posted: Wed Jun 25, 2008 10:32 pm
by mopherman
The best way to learn all about fittings is just to dive into the plumbing isle at your local hardware. Yeah, those bushings will work, but I would strongly recommend just going out to Lowes or HD and getting your hands on the stuff.
Posted: Wed Jun 25, 2008 11:24 pm
by Flash
Going to the plumbing section at Lowes or something helps a lot. It quickly shows you how fittings are supposed to be used.
Posted: Wed Jun 25, 2008 11:32 pm
by DrowningTrout
Yea, I went to Lowes and Home Depot, and both of them were lacking inventory, HD was terrible... (small one here)
Anyways I ordered the bushings online! Thanks For the help all!