Quicker way to make muzzle knife?
just tape some sand paper to the floor and scrape the pipe on it. it took me like 5 minutes. btw i also love the piston hybrid _fnord. Why dont you post it?
searching for a modern day savior from another place,inclined toward charity,everyone's begging for an answer,without regard to validity,the searching never ends,it goes on and on for eternity
-Bad religion
-Bad religion
if your careful, it'l be even. the only problem is that you cant get and inner taper on the pipe.
searching for a modern day savior from another place,inclined toward charity,everyone's begging for an answer,without regard to validity,the searching never ends,it goes on and on for eternity
-Bad religion
-Bad religion
-
iPaintball
- Corporal 2
- Posts: 695
- Joined: Sun Mar 04, 2007 8:37 pm
A very easy method is to find some medium grit pavement 
and drag the barrel behind you while applying pressure and rotating it at the same time.
and drag the barrel behind you while applying pressure and rotating it at the same time.Summer Projects:
CO2 tank hybrid: Gotta fix the meter
Cane gun: Needs a pilot/fill setup
1.5" piston valve gun: Almost done
CO2 tank hybrid: Gotta fix the meter
Cane gun: Needs a pilot/fill setup
1.5" piston valve gun: Almost done
Well, I'm going to saw off the cheese-grader grade job I've done already and try the sandpaper-on-floor technique. 
-
Flying_Salt
- Corporal 3
- Posts: 779
- Joined: Mon Oct 09, 2006 4:57 pm
- Location: Texas
Maybe a lawn egder and a big clamp?
If you have a smaller barrel you could attack it with a dremel, or tapesandpaper to a drill.
If you have a smaller barrel you could attack it with a dremel, or tapesandpaper to a drill.
sgort87 wrote: I hereby present Flying_Salt with The one and only <a href="http://www.geocities.com/sgort87/ghetto">Ghetto Award!</a>
A rasp would be good eventually, as noname said. But, what I have done before is to use a utility knife. Whittle it down and it doesn't take too long to smooth it out with paper.
I'm weird, I know it, you don't need to tell me.
i big pencil sharpener they wouldn't be that hard to make realy
they wouldn't be that hard to make realy
A huge pencil sharpener? lol. I think I will make one like on www.burntlatke.com . Thanks for all the ideas! Well, I just finished cementing
my chamber together, all I have to do is grind down that barrel/make cutter and then I'm done with my first gun
gosh... those abs cement fumes REEK.
my chamber together, all I have to do is grind down that barrel/make cutter and then I'm done with my first gun
gosh... those abs cement fumes REEK.
