Gday chums
i have a propane cylinder sitting in the shed right now needing a home and i was wondering if i could use it on my cannon
http://www.spudfiles.com/forums/50mm-bo ... 16755.html
because im not sure if i can use it on Aussie DWV or what not. cos i have noticed my fittings are different from the ones you American blokes use.
just checking, dont want to die any time soon
cheers guys
Australian fittings + propane = ?
- Cosmic Muffin
- Specialist 2
- Posts: 275
- Joined: Mon Jan 14, 2008 10:30 pm
- Location: arse end of nowhere
You won't die any time soon.....well from spudding anyway....
You should be OK to go with metered propane in your little beauty. However, the rear cap is the only thing that would concern me a tad. Is there another type cap that's pressure rated that you could screw on there? Any time you see flat boundries like that you have to be a little concerned.
If it were a pneumatic, I would say no way. Have you figured out how you want to meter and inject the fuel?
You should be OK to go with metered propane in your little beauty. However, the rear cap is the only thing that would concern me a tad. Is there another type cap that's pressure rated that you could screw on there? Any time you see flat boundries like that you have to be a little concerned.
If it were a pneumatic, I would say no way. Have you figured out how you want to meter and inject the fuel?
- Cosmic Muffin
- Specialist 2
- Posts: 275
- Joined: Mon Jan 14, 2008 10:30 pm
- Location: arse end of nowhere
cheers carlman. but whats IMHO
tha rear cap is the only thing i have seen in 90mm, i cant find 90mm pressure rated parts and i have been to heaps of different stores.
i could just cut the whole section off and replace it with a bell reducer. then have a ball valve in that.
hmmm
is there an amount of propane equal to the explosive power of aerosol?.
cos im only really interested in metering so that i don't have to "pray"
and no i havent thought that far ahead yet starman.
tha rear cap is the only thing i have seen in 90mm, i cant find 90mm pressure rated parts and i have been to heaps of different stores.
i could just cut the whole section off and replace it with a bell reducer. then have a ball valve in that.
hmmm
is there an amount of propane equal to the explosive power of aerosol?.
cos im only really interested in metering so that i don't have to "pray"
and no i havent thought that far ahead yet starman.
Properly metered propane will be more energetic and more consistent than your aerosol. It's time to be thinking about it...Cosmic Muffin wrote:is there an amount of propane equal to the explosive power of aerosol?.
cos im only really interested in metering so that i don't have to "pray"
and no i havent thought that far ahead yet starman.
IMHO = In My Humble Opinion
- Cosmic Muffin
- Specialist 2
- Posts: 275
- Joined: Mon Jan 14, 2008 10:30 pm
- Location: arse end of nowhere
yer well im after the consistency.
just dont want to blow the chamber up.
oh cheers
imho
i see
just dont want to blow the chamber up.
oh cheers
imho
i see