A place for general potato gun questions and discussions.
-
quiggly17
- Private 3
- Posts: 45
- Joined: Sun Aug 12, 2007 10:10 am
Thu Apr 17, 2008 3:21 pm
I have looked around and i was wondering whats the best way to make a piston for a 1in brass tee
-
jrrdw
- Moderator
- Posts: 6572
- Joined: Wed Nov 16, 2005 5:11 pm
- Location: Maryland
- Has thanked: 39 times
- Been thanked: 22 times
-
Contact:
-
Antonio
- Corporal
- Posts: 508
- Joined: Sun Aug 13, 2006 2:38 pm
Fri Apr 18, 2008 2:49 pm
you gotta check with pigelo. (not sure about the name) He made a copper piston, I think his piston was from epoxy.
-
hyldgaard
- Specialist
- Posts: 187
- Joined: Tue Sep 25, 2007 4:21 am
- Location: Denmark
Fri Apr 18, 2008 3:16 pm
I have with great succes made a piston as large as 18mm from copper, and used it to a bit over 450psi. As long as you stay low on weight aside from the copper, i would believe its possible to use that method with a 1" piston too.
