crosman co2 phantom valve

dungdue0 · Fri Oct 21, 2011 11:29 am

i just bought this gun http://www.walmart.com/ip/Crosman-P10-P ... l/15103493

yes i now know it sucks anyways i took it apart to retrieve valve assembly. My question is if anyone has played with the valve assembly. It houses a 12gram and all. I just cant figure out a good trigger settup to get costant flow. Any help is appreciate

Fri Oct 21, 2011 11:43 am

Constant as in continueous or constant like in consistent?

Gun Freak · Fri Oct 21, 2011 11:53 am

What exactly are you trying to do? Make it more powerful?

pneumaticcannons · Fri Oct 21, 2011 1:05 pm

as gun freak said, it help if you told us what your trying to do with it.

dungdue0 · Fri Oct 21, 2011 2:00 pm

Im trying to get a constant flow, i dont care about the pressure output or anything i just need to figure out a trigger assembly to give me the constant flow without losing pressure

Mr.Tallahassee · Fri Oct 21, 2011 2:14 pm

So you mean a continuous flow?

Gun Freak · Fri Oct 21, 2011 2:23 pm

constant flow without losing pressure

That makes no sense.

Constant flow, meaning dump the entire cartridge at once? Pretty sure there's pressure loss there.

Mr.Tallahassee · Fri Oct 21, 2011 2:29 pm

Gun Freak wrote:Pretty sure there's pressure loss there.

Actually, there's enough liquid CO2 to maintain just under 700 PSI for about three seconds.

If you want constant flow for some time, try to adapt the valving to fit a 20oz CO2 bottle or maybe a regulated HPA bottle. They have a much higher volume of gas and will last considerably longer.

Gun Freak · Fri Oct 21, 2011 3:59 pm

Constant flow, meaning dump the entire cartridge at once? Pretty sure there's pressure loss there.

Actually, there's enough liquid CO2 to maintain just under 700 PSI for about three seconds.

dungdue0 · Fri Oct 21, 2011 5:31 pm

Gun Freak wrote:
constant flow without losing pressure
That makes no sense.

Constant flow, meaning dump the entire cartridge at once? Pretty sure there's pressure loss there.

no, i meant i need a trigger assembly that allows for constant flow without loosing excess pressure due to leaks since it is a hammer valve

dungdue0 · Sat Oct 22, 2011 10:38 am

I hope im explaining this correctly, could really use yalls input

pneumaticcannons · Sat Oct 22, 2011 11:48 am

tape the valve open

cammyd32 · Sat Oct 22, 2011 1:02 pm

Are you intending to just edit the existing mechanism, or just put the bits you need in a completely new shell?

dungdue0 · Sat Oct 22, 2011 3:35 pm

the bits in a completely new shell. but thats beside the point. I need a way to actuate the valve without loosing any pressure

Gun Freak · Sat Oct 22, 2011 5:09 pm

You will always use pressure, what don't you understand

Question is not making much sense to me. Anyone care to enlighten me?