mapp gas shortage
-
- Private
- Posts: 9
- Joined: Wed May 02, 2012 3:33 pm
- Location: pennsylvania
I was reading posts and somebody had mentioned a mysterious mapp gas shortage. Evidently the major mapp gas supplier has issued a recall for faulty canisters whcih have caused severe burns and injuries. Thought you guys should know.
- mark.f
- Sergeant Major 4
- Posts: 3638
- Joined: Sat May 06, 2006 11:18 am
- Location: The Big Steezy
- Has thanked: 58 times
- Been thanked: 59 times
- Contact:
The actual MAPP gas hasn't been produced for a while now, with companies switching to MAP/Pro which is basically propylene. The supplier for MAPP gas closed down.
Is the MAP gas ok for spudguns ?.. or is it only the MAPP gas that performs better than propane ?..
I think we only get MAP here in norway atm... And not woth using if its no better than propane, or dangerous.
I think we only get MAP here in norway atm... And not woth using if its no better than propane, or dangerous.
To make dreams come true, u must wake up.
- Crna Legija
- First Sergeant 2
- Posts: 2333
- Joined: Sun Jul 20, 2008 5:14 am
- Location: australia
Mapp is better then propane although you probably wont notice the difference, also you need to meter 4.6% not 4.2% like you would for propane.
'' To alcohol... The cause of, and solution to, all of life's problems.”
--Homer Simpson
Add me on ps3: wannafuk, 8/11/11 cant wait
--Homer Simpson
Add me on ps3: wannafuk, 8/11/11 cant wait
- jimmy101
- Sergeant Major
- Posts: 3199
- Joined: Wed Mar 28, 2007 9:48 am
- Location: Greenwood, Indiana
- Has thanked: 5 times
- Been thanked: 17 times
- Contact:
MAPP is a trademark, MAP isn't.natas wrote:so no difference between MAP and MAPP ?
According to Wikipedia, MAPP production was discontinued in 2008.
http://en.wikipedia.org/wiki/MAPP_gas
The challenge with MAP (and MAPP) is that the percentage of the various components isn't always the same. That makes getting the proper fuel ratio tricky.
http://www.airgas.com/documents/pdf/002015.pdf
http://www.magtorch.com/MAPP_MSDS_8-1-2007.pdf
http://www.weilerwelding.com/MSDS/2015.pdf