how to clean the inside chamber

[spudzooka98]

I was wondering how to clean the inside of the chamber of a combustion gun. I have a very simple gun with a sparker in the end cap no fan or nothing. so I keep getting this gunk in the chamber(i know hair spray does that )How do i clean it out the cap is getting harder and harder to take out also will axe make gunk in the gun to

[flashskate13]

if its just gunk then i would use a degrease spray or white sprite and wipe clean with a cloth

[jrrdw]

Any type of fuel burned is going to leave behind a byproduct. Rubbing alcohol is a good cleaner, soak a rag and wipe it out.

White Sprite, the soda?

[spudzooka98]

that is what i thought soda but will rubbing alchohol help the threads on the gun so the cap wont get stuck

[flashskate13]

Lol white sprite in the uk is rubbing alcohol

[jrrdw]

that is what i thought soda but will rubbing alcohol help the threads on the gun so the cap wont get stuck

Soak the rag good and put some umf into it. May take a splashing on the threads, let it soak a minute or two then wipe it out. But yea rubbing alcohol will break most petroleum distillates down pretty easily.

Lol white sprite in the uk is rubbing alcohol

Thanks for the laugh...

[CS]

You might consider using starting fluid. It is common, cheap, and doesn't have as much byproduct as its function is to burn. After a while a greasy layer will build up. To get rid of it I would light it on fire, don't stare in the chamber (you probably will), and quickly wave the launcher around to put it out. To long and the plastic would start to melt.

[spudzooka98]

cool thanks my buddie told me if i use starter fluid make sure i have the pieces to fix it