How do u muzzle breake your barrel
-
jackssmirkingrevenge
- Five Star General
- Posts: 26203
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 569 times
- Been thanked: 344 times
It doesn't matter, completely useless on a small pneumatic...
hectmarr wrote:You have to make many weapons, because this field is long and short life
Porting works to bleed off excess gas, for a pneumatic like yours, which has a massive excess anyway, no amount of porting will hell you just can't deliver that little gas through a QEV.
Not to mention the effect is so minimal, you won't notice until you really get into it, and this comes from an airsoft bloke.
Not to mention the effect is so minimal, you won't notice until you really get into it, and this comes from an airsoft bloke.
/sarcasm, /hyperbole
Unless you're going for a hammer valve, it honestly won't help, bar reducing velocity by a few FPS. Concentrate on a stable hopup if you're using one, I prefer R-Hops myself, but I've seen good results from an E I hop too.
Get a 6.04mm barrel, as long as you like, even drop the hopup for a thing called an LRB, which curves the barrel instead of spinning the BB, far better.
The fella who runs AirOZ is a top bloke, always ships that quickly.
Get a 6.04mm barrel, as long as you like, even drop the hopup for a thing called an LRB, which curves the barrel instead of spinning the BB, far better.
The fella who runs AirOZ is a top bloke, always ships that quickly.
/sarcasm, /hyperbole