ideas for multiple spark points
I am building another cannon and I am moving up from the "spray and pray " style to a metered direct propane injection. I have seen some people use screws but I want some ideas on other ways. I am looking to try and have 3 spark points inside the combustion chamber. I am using a 12kv electric BBQ spark source. Any ideas?
-
jackssmirkingrevenge
- Five Star General
- Posts: 26203
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 569 times
- Been thanked: 345 times
hectmarr wrote:You have to make many weapons, because this field is long and short life
-
jackssmirkingrevenge
- Five Star General
- Posts: 26203
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 569 times
- Been thanked: 345 times
How do you know, what did you do exactly?rdunajek wrote:I like that but it is less effective than say screws. What I am really wanting to know is if screws in the chamber the best way for the most power?
It's not really about what you use as electrodes, rather the power of your ignition source and the number and position of your spark gaps.
For example, three small spark gaps in the front, middle and rear of the chamber will be more effective than a single large spark in the middle of the chamber. If you had three spark gaps but still kept them clustered together, you're not going to see much difference in power.
hectmarr wrote:You have to make many weapons, because this field is long and short life
-
jimmy101
- Sergeant Major
- Posts: 3199
- Joined: Wed Mar 28, 2007 9:48 am
- Location: Greenwood, Indiana
- Has thanked: 5 times
- Been thanked: 17 times
- Contact:
Where the sparks are probably does matter. The spark strip in Jack's link puts the sparks up against the wall and the resulting flame front is less than a hemisphere. If the spark gaps are out near the central axis of the chamber you can get spherical flame fronts for part of the combustion process. Seems to me that the optimum multigap setup would have the gaps near the chamber's axis and there would be a spark gap every chamber diameter. A 3" diameter change would have spark gaps at 1.5, 4.5, 7.5, ...
Here are a couple ways to do the wiring (and some wrong ways).
you can put the wires between the electrodes inside the chamber.
Here are a couple ways to do the wiring (and some wrong ways).
you can put the wires between the electrodes inside the chamber.
OK that's what I was looking for. I am not wild about drilling a bunch of screw in my chamber but what you are showing just 2 holes and multiple sparks in the center throughout the chamber. I bought everything for the propane meter today and going to sch 80 PVC tomorrow. After I get it built I will be posting pics.
