I have some 2" galvanized conduit pipe, and it is thicker than a dot-39 tank(the most common green propane tank in this area).
You would be better off with brass/steel if you dont mind spending more.
custom propane tank
-
turbohacker
- Specialist 3
- Posts: 392
- Joined: Wed Dec 20, 2006 12:34 am
For your liquid propane problom I would suggest putting a smaller tank above the liquid filled one, when you open a ball valve than the gas will expand before it gets to the regulator
<-- This is not a cat avatar
If it walks like a dog, sratches like a dog, and barks like a dog, than its probobly a...-TURTLE, it's a TURTLE!!! Cant you see?!!!
If it walks like a dog, sratches like a dog, and barks like a dog, than its probobly a...-TURTLE, it's a TURTLE!!! Cant you see?!!!
frankrede wrote:Great googlay mooglay!
Thats a beast!
good idea, turbohacker, i'll probably try that. and for the tank, i'm probably just going to use a half inch galvanized steel nipple, a few inches long, which is only going to cost like five to ten dollars, including the fittings, so its actually not that bad. im bussy now with finals, but school gets out monday so then i'll be able to try this out.
oh and i just remembered another idea i had, what if i used some sort of clear tubing so i could see how much propane was left? is there some such tubing that i could trust to hold the pressure over somewhat extended periods of time? like that stuff with crisscrossing nylon reinforcing fibers in it? there's got to be something. and then you could always see exactly how much you have left, which would be really cool.
oh and i just remembered another idea i had, what if i used some sort of clear tubing so i could see how much propane was left? is there some such tubing that i could trust to hold the pressure over somewhat extended periods of time? like that stuff with crisscrossing nylon reinforcing fibers in it? there's got to be something. and then you could always see exactly how much you have left, which would be really cool.
Propane at temperatures >100C is a liquid under compression if he used clear materials for the cylinder he would see "liquid propane"sandman wrote:wait, how do you plan on seeing a gas?
i know you can see the liquid propane, i've had it get in the tube that goes to the regulator, and you can see it in there. and until you run out of liquid, the pressure in the tank remains constant. and it wouldn't have to be cold, just under pressure, varying from about 75 psi at 50ºF (10ºC) to 175psi at 100ºF (38ºC). i dont think the temp would get beyond that range, and if anything it would get colder than that which wouldn't be a problem in terms of tubing being able to hold the pressure.
sooo...back to the original question: is there some sort of tubing that would work for this while providing a visual on how much propane is left?
sooo...back to the original question: is there some sort of tubing that would work for this while providing a visual on how much propane is left?
chaos wrote:Propane at temperatures >100C is a liquid under compression if he used clear materials for the cylinder he would see "liquid propane"sandman wrote:wait, how do you plan on seeing a gas?
sandman wrote:but how would you get it cold enough to see how much is in there if you already used most of it?
did i not explain it enuf for you?
meatballs there is a way to do it im sure of it, i mean find out the chemical resistance of clear pvc... thats it done there. sch80 clear pvc IF it can withstand the chemical properties of propane should be fine.
